User's Manual

5–9
10004880 Rev. D1
Chapter 5. The PacketWave AIM
14. When you have finished specifying configuration parameters, click on the Next>>
button.
15. If you logged on using the default password, the AIM will prompt for a more secure
password as shown in Figure 5-8.
WARNING: Once the new password has been selected, there will be no default
password for emergency access. Therefore, be careful not to lose the
password.
If you are ready to specify the permanent AIM password, enter the new password.
Otherwise, enter isp to retain the default password. Then click OK.
NOTE: If you retain the default password by entering isp, the Change Password
window will be displayed again the next time the AIM Setup mode is used.
Figure 5-8 Change Password Window
16. After you click Next>> in the Configuration Window (and specify a new password is
necessary), the AIM will send the configuration choices to the PacketWave 200,
then reset the device. The status windows shown in Figure 5-9 will be displayed,
the one on the left first followed by the one on the right.
17. When the restart is finished, the AIM will go into antenna alignment mode, display-
ing the Alignment Window shown in Figure 5-10.