User's Manual

Chapter 5. The PacketWave AIM
5–4
10004880 Rev. D1
5. The Installation Option Window will be displayed, as shown in Figure 5-3. This win-
dow presents five AIM modes:
•Setup
SetupSetup
Setup provides the complete AIM functionality: basic configuration, antenna
alignment, and throughput testing. To use this option, proceed to the next
section, Basic Configuration.
• Continue with Setup
Continue with SetupContinue with Setup
Continue with Setup is used for antenna alignment when basic configuration
has already been completed. (Use this option if antenna alignment was not
successfully completed for a preconfigured PacketWave 200.) To use this
mode, follow the instructions under Re-aligning the Antenna (Continue with
Setup Mode) on page 5-15.
•Link Status
Link StatusLink Status
Link Status displays graphs of the status of the wireless link. To use this
mode, follow the instructions under Viewing Status of the Wireless Link (Link
Status Mode) on page 5-16.
• Test only provides direct access to the ping and throughput tests. To use this
mode, follow the instructions under Running a Non-Destructive Test (Test
Mode) on page 5-17.
• Provision provides access to the basic configuration without proceeding to
antenna alignment; it allows pre-provisioning of the unit prior to installation,
and enables the audio auto-alignment feature described in Chapter 4. To use
this mode, follow the instructions under Pre-provisioning a PW200 for Later
Installation (Provision Mode) on page 5-18.
Figure 5-3 Install Option Window