User's Manual

Chapter 2. Overview
2–6
10004880 Rev. D1
Built-In Server, Client, Agent, and Router Functions
Servers, agent/client, and router functions are built into PacketWave 200:
• DHCP Client — All PacketWave Series 200 models include a Dynamic Host
Configuration Protocol (DHCP) client for local address management by the Base
Station Unit’s assigned DHCP server.
• DHCP Server — PacketWave 220 and 230 models include a Dynamic Host
Configuration Protocol (DHCP) server for local address management.
• NAT Server — PacketWave 220 and 230 models include a built-in NAT (Network
Address Translation) server.
• IP Router — PacketWave 230 models include a built-in IP router.
• SNMP Agent — All PacketWave Series 200 models include an SNMP agent for inte-
gration of the PacketWave network into an SNMP management system.
• PPPoE Client — PacketWave 220 and 230 models include a built-in PPPoE (PPP
over Ethernet) server.
PacketWave 200 LEDs
The LEDs on the Outdoor Unit and Interface Box provide operational information as
described in Table 2-A.
Table 2-A PacketWave 200 LEDs
LED Indications
Outdoor
Unit
Left Wireless Tx:
Blinks on Wireless transmit activity.
Middle Wireless Rx:
Blinks on Wireless receive activity.
Right
On when Ethernet link is up; Off when it is down.
Interface
Box
ODU Port, left
On when the Interface Box is powered on.
ODU Port, Right
On when power is provided to the Outdoor Unit.
LEDs for the LAN port on the Interface Box are always off.