User's Manual

2–7
070-20000750-01 Rev A
Chapter 2. Installation and Configuration
Link Distance should be set to the correct distance or the next higher equivalent. Values
of 10,20,30,40, and 50 KM are available.
AIM will calculate the correct frame parameters for the values you have entered.
Please skip ahead to the Results step.
Accept the Default Configuration Parameters
If you are here, you chose the Continue with setup Installation mode. If you chose the
Setup option please skip to the next step.
You should now see a window as shown in Figure 2-5. AIM has retrieved the MAC address
of the Aperto unit. If you believe this is incorrect, use the Previous and then the Next but-
tons to proceed to the previous window and then back again.
If the information is correct, click on the next button.
Figure 2-5 Configuration Window - Continuing with Installation
Allow AIM to Configure the PacketWave
When you click on the next button from either the Setup or Continue with Setup Configu-
ration window, AIM sends the parameters to the Aperto PW620.