User's Manual

1–9
070-20000750-01 Rev A
Chapter 1. Overview
Radio Signal Connection
To install the radio signal cable, perform the following steps
1. Obtain an appropriate length of cable, and run it from the Indoor Unit to the Out-
door Unit. Include a service/drip loop as appropriate.
2. Install a male F connector at each end of the cable.
3. Attach the cable to the female F connector on the Outdoor Unit, as shown in
Figure 1-6. Tighten the connector until the cable is firmly secured, but do not over-
tighten.
4. Attach the cable to the Radio IF connector on the Indoor Unit as illustrated in
Figure 1-7.
The Radio Control connector of the Indoor Unit has the same physical appearance
as the 10/100Base-T connector. Make sure you connect to the right one.
5. Dress the cable as appropriate.
Radio Control Connection
To install the radio control cable, perform the following steps
1. Obtain an appropriate length of cable, and run it from the Indoor Unit to the Out-
door Unit. Include a service/drip loop as appropriate.
2. Place the supplied rubber boot over the radio/antenna end of the cable.
3. Install an RJ45 male connector on each end of the cable.
4. Plug the cable into the RJ45 socket on the Outdoor Unit as shown in Figure 1-6.
5. Slide the rubber boot over the R-J45 connection so that it is tight against the radio/
antenna housing; then secure the boot in place with a cable tie.
6. Attach the cable to the Radio Control connector on the Indoor Unit as shown in
Figure 1-7.
7. Dress the cable as appropriate.
Seal the entry of both cables to the building as appropriate.