User's Manual Part 1

2–21
070-20000750-01 Rev A
Chapter 2. Installation and Configuration
Problem with Signal Indicator in Installation Manager
When using Installation Manager, if the signal does not move up from the bottom of the
Signal Indicator graph (i.e., shows -100 dBm), follow the instructions below.
If the installation has line-of-sight to the Base Station antenna, you should know the gen-
eral direction to point the Outdoor Unit. Start in that direction. Move the Outdoor Unit
every few seconds until you see the Signal Indicator line raises at lease once. Once it
raises, slow the movement of the antenna, checking the SIGNAL INDICATOR as well as the
SNR. If nothing appears after 2 to 3 minutes, it is best to click the Previous and then the
Next buttons to reset sequence.
If the installation is not line-of-sight, either search for a first synchronization from the base
station (as indicated by the rise of the Signal Indicator line) or just pick a direction to point
your antenna. In either case, the SU will begin to adjust your 10 MHz reference clock. After
two minutes, either the SU has found synchronization, or it needs to be reset by clicking
on the Previous and then the Next buttons. If you chose to leave the antenna in a static
direction, move that antenna 20 degrees after it has been reset.