User's Manual Part 1

Chapter 2. Installation and Configuration
2–12
070-20000750-01 Rev A
Accept the Default Configuration Parameters
You came to this step because you chose Continue with setup. If you chose Setup as your
install option, please skip ahead to the next step.
This step is exactly the same as with the PW620 so please refer to Figure 2-5 on page -7
for the correct instructions. Click on the Next button
Allow AIM to Configure the PacketWave
AIM now uses the information you gave (or the information stored in the Aperto unit if you
came with the Continue with setup option) to configure the Aperto unit. AIM will send all
of the parameters you entered and some calculated parameters to the Aperto unit.
WARNING: One of the items AIM sends to the Aperto unit is a calculated IP address
and subnet so AIM can communicate with the Aperto unit using stan-
dard TCP/IP. If you begin the alignment step and do not terminate it suc-
cessfully, the IP address of the PW610 will remain with the address
calculated by AIM, not the address you gave in the AIM parameters.
Only after a successful completion of antenna alignment will the IP
address be as you entered.
The PW610 will be reset and it will go into antenna alignment mode. Once the PW610 is
ready for antenna pointing, AIM will proceed to the alignment window automatically.