User's Manual Part 1

Chapter 2. Installation and Configuration
2–10
070-20000750-01 Rev A
Choose the Installation Mode
The installation modes of the PW610 vary from that of the PW620. You will note that there
is now a Test Only mode. The first two modes are the same with either the PW620 or the
PW610. Test Only mode provides a ping and through-put test that is non-destructive.
Figure 2-8 below shows the three options. choose one and click on the Next button.
Figure 2-8 Install Option Window for the PW610
Fill Out the Configuration Parameters
You come to the Configuration Parameters window as seen in Figure 2-9 because you
selected Setup as your Install Option. If you chose the Continue with setup, skip to the
next step.
As you can see from Figure 2-9 below, the configuration parameters of the PW610 are
much the same as the PW620. The screen’s appearance is simplified due to the fact that
the frequency band and channel are not presented. Aperto assumes that once this has