User's Manual Part 1

Chapter 2. Installation and Configuration
2–6
070-20000750-01 Rev A
(5.725 - 5.825 GHz) value. It is suggested that you leave the channel width to the current
selection of 6.
.
Figure 2-4 Configuration Window from Setup
Please select an appropriate channel center frequency. The values range from 5728 to
5822.This is the center of a 6MHz channel. You may move the frequency up or down within
that range in 1 MHz values.
Hopefully, you have planned carefully and have an appropriate value in mind. Aperto has
no way of offering a suggestion for a default value appropriate to your area. As soon as
you configure the PW620, it will begin transmitting.
Choose the IP address, Subnet mask, and Default gateway appropriate for your PW620.
This should be a unique address in the network to which you attach the PacketWave 600
series units. It is important to remember that the IP subnet you choose will include an
address for the PW610. Thus, both units of your PacketWave 600 series should have a
unique address in the same subnet.
The antenna polarity of the PW620 should match that of the PW610. Antenna polarity and
diversity will be discussed later in this document. The “Vertical” default is a good choice.
Band 1st time only
Width 1st time only
read f rom device
IP Addressing
read from device
Always add your
ow n frequency