User's Manual Part 1

2–3
070-20000750-01 Rev A
Chapter 2. Installation and Configuration
an example of setting a fixed IP address on Windows 2000. Be sure to choose the “Use
the following IP address” selection.
Figure 2-1 Windows 2000 IP Address Setting
WARNING: You cannot rely of executing an “ipconfig” command to tell you if you
have a fixed IP address. Often errors have occurred due to the fact that
what appeared to be a fixed address was none the less a dynamic IP
address and communications were lost when the Aperto device reboo-
ted to set the parameters permanently.
Start the Application
Double-click on the “Advanced Installation Manager 1.0” (AIM) icon on your desktop. If it
is installed properly, you should see the Authentication window, Figure 2-2shown below.
Please note the buttons at the bottom of the window.
The AIM application is much like a wizard program. You may move to the next or previous
window as you wish. Each time you move from window to window some process is per-
formed for you.
WARNING: If the PC and the PW620 are not connected properly you will see the
warning shown in the graphic below when you click on the next button.