User's Manual Part 1

2–1
070-20000750-01 Rev A
2
Installation and Configuration
Installation and configuration of the PacketWave 600 series are provided in this chapter.
Introduction
The PacketWave series 600, point-to-point system consists of two indoor and two outdoor
units. The indoor units have master and slave capabilities. The slave unit is the Packet-
Wave 610 and the master unit is the PacketWave 620.
The installation software that help you configure, install, and aim your antenna is the
Advanced Installation Manager (AIM).
What you will need
The PacketWave series 600 kit is supplied with everything you need. The only additional
equipment you’ll need is an Ethernet cross-over cable and a PC (or PC compatible) with
an Ethernet connection and enough memory and disk space to run the Java application.
We suggest
a laptop PC with 256 Mbyte memory, 10 GB disk drive, Pentium
processor, and ethernet LAN connection. Systems as small as 128 Mbyte mem-
ory and a 386 processor have been used. They do work, but not very satisfac-
torily.
Getting started
Preparing the PC
The PacketWave 600 comes with Java software from SUN Microsystems.