User's Manual

7–13070-20000330-01 Rev A
C
HAPTER
7. M
ANAGEMENT
I
NTERFACES
C
OMMAND
L
INE
I
NTERFACE
(CLI)
Each Indoor Unit includes a simple command line interface (CLI) accessible via tel-
net.
To use the CLI:
1. Telnet to the Indoor Unit’s IP address.
2. Enter the correct user name (Aperto) and password (Aperto) as prompted.
3. When the CLI# prompt appears, you are in the CLI. For a list of commands,
type ? (the ? will not appear on the screen). The CLI will respond with a list
of the available commands groups, as shown in Figure 7-12.
4. To see the specific commands in a group, type the group name followed by ?
(again, the ? will not appear). Figure 7-12 shows the commands in each group.
5. To display information about the use of a specific commands, including com-
mand parameters, enter the command followed by ?.
Figure 7-12 Example of Command Line Interface (CLI)
6. Use the CLI commands to show configuration data, set the channel frequency,
and/or reboot the unit, as desired
7. If there is no activity on a connection for 30 minutes, the CLI will disconnect.
8. When you are finished with the CLI, disconnect.