User's Manual
Table Of Contents
- Scope of This Manual
- Conventions Used in This Manual
- Intended Audience for this Manual
- General Cautions and Warnings
- QuickStart Guide
- Overview
- Site Planning
- Outdoor Unit Installation
- Indoor Unit Installation
- Starting Up
- Management Interfaces
5–5070-20000330-01 Rev A
C
HAPTER
5. I
NDOOR
U
NIT
I
NSTALLATION
Powering Up the Indoor Unit
To apply power to the Indoor Unit:
1. Plug the power cord into the POWER connector on the Indoor Unit, as illus-
trated in Figure 5-5.
2. Plug the power cord/transformer into a grounded wall outlet.
The Indoor Unit does not have an on/off switch; to turn the unit off, disconnect power
at either the rear panel or the wall socket.
The Outdoor Unit receives power from the Indoor Unit (or a separate power source)
via the coaxial radio signal cable.
Figure 5-4 Indoor Unit Power Connection
To wall outlet