User's Manual

iii070-20000330-01
REGULATORY INFORMATION
PART 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two con-
ditions:
1) this device may not cause harmful electromagnetic interference, and
2) this device must accept any interference received includinginterference that may cause undes-
ired operations.
FCC NOTICE: Radio and Television Interference
The PacketWave 100 Series Subscriber Equipment has been tested and found to comply with the lim-
its for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used according to the
instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which is found by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment or device.
• Connect the equipment to an outlet other than the receiver's.
• Consult a dealer or an experienced radio/TV technician for assistance.
RF Exposure Notice
The installer shall mount all transmit antennas so as to comply with the limits for human
exposure to radio frequency (RF) fields per paragraph 1.1307 of FCC regulations. The
FCC requirements incorporate limits for Maximum Permissible Exposure (MPE) in
terms of electric field strength, magnetic field strength, and power density
CAUTION
To comply with FCC RF exposure requirements, antennas used for this device must be
installed to provide a separation distance of at least 1.5m from all persons to satisfy RF
exposure compliance.