User's Manual

C
HAPTER
4. O
UTDOOR
U
NIT
I
NSTALLATION
4–2070-20000330-01 Rev A
M
OUNTING THE
O
UTDOOR
U
NIT
(R
ADIO
/A
NTENNA
)
Subscriber Outdoor Units are designed for mounting on a pole or antenna mast with
a diameter of 1.5 inch, 2 inches, or 5 cm, using a rear-mounted bracket as shown in
Figure 4-1.
To mount an Outdoor Unit on a pole:
1. Loosen the pole clamp bolt and open the pole clamp.
2. Close the pole clamp around the pole.
3. Adjust the direction and elevation of the radio/antenna.
4. Tighten the pole clamp bolt until the Outdoor Unit is secured in position.
Figure 4-1 Outdoor Unit Mounting Bracket
Other mounting options, such as under an eave or in a window, can also be employed.
In such cases, appropriate mounting hardware must be obtained.
R
UNNING
C
ABLES
B
ETWEEN
O
UTDOOR AND
I
NDOOR
U
NITS
As described in Chapter 2, there are two cables that connect the Outdoor Unit to the
Indoor Unit:
• A quad shield coaxial cable for the subscriber signal (which also provides 12
V dc power to the Outdoor Unit).
• A shielded Cat 5 cable for controlling the Outdoor Unit.
The connectors on the Outdoor Unit are located on the back, at the bottom of the radio
enclosure.