User's Manual
Table Of Contents
- Scope of This Manual
- Conventions Used in This Manual
- Intended Audience for this Manual
- General Cautions and Warnings
- QuickStart Guide
- Overview
- Site Planning
- Outdoor Unit Installation
- Indoor Unit Installation
- Starting Up
- Management Interfaces
2–3070-20000330-01 Rev A
C
HAPTER
2. O
VERVIEW
Indoor Unit
The PacketWave 100 Series Indoor Unit is a bridge/router which provides the link
between the subscriber’s computer(s) and the outdoor radio/antenna for the wireless
service. The first available model, the PacketWave 130 supports bridging and NAT
modes. IP routing will be supported in the next major software release.
On the radio/antenna side, the Indoor Unit has two interfaces:
• A port for wireless traffic (which also provides power to the Outdoor Unit).
• A port for controlling the radio/antenna.
On the subscriber side, the Indoor Unit has an auto-negotiating 10/100Base-T Ethernet
port. The Indoor Unit plugs into a standard ac wall plug (120 or 220 volts). A power
cord with transformer is provided with the unit.
Figure 2-3 PacketWave 130 Indoor Unit
Bridging Mode
NAT Mode