User's Manual

1–1070-20000330-01 Rev A
1
Q
UICK
S
TART
G
UIDE
This chapter outlines the basic procedure for installing PacketWave 100 Series
Subscriber Equipment and putting it into operation. It identifies the minimal require-
ments for getting the equipment up and running, and assumes that configuration using
DHCP and WaveCenter™ Configuration Manager has been performed as described
in the PacketWave 1000 Base Station Unit manual.
WARNING: This QuickStart Guide assumes that outdoor installation proce-
dures will be performed by qualified professionals following all
safety and other requirements and acting in accordance with
standard practices and procedures. Failure to meet safety
requirements and/or non-standard practices and procedures
could result in personal injury and/or damage to equipment.
All of the instructions presented in this chapter are discussed in more detail in subse-
quent chapters of this manual.
Step 1. Prepare for Installation
A. Before visiting the subscriber’s site:
i. Make sure that the necessary system configuration has taken place (as
described in the PacketWave 1000 Base Station Unit manual).
ii. Make sure that the system’s DHCP and TFTP servers are running.
iii. Verify that the subscriber configuration file has been created and saved on
the TFTP server.
iv. Verify that the DHCP server has been configured with the subscriber’s IP
and MAC addresses and its configuration file name.