User's Manual

CHAPTER 6. BSU AND S UBSCRIBER CONFIGURATION
6–10070-20000340-01 Rev A
There are four first-level menu tabs for BSU configuration, as shown by the upper
row of tabs in Figure6-3:
• WSS — Used to configure each wireless subsystem (radio interface) on the
Base Station Unit.
• Main — Used to specify various parameters for the Base Station Unit itself.
• SNMP — Used to configure the Base Station Unit for SNMP management.
• Alerts — Used to configure the Base Station Unit for email event alerts.
Configuring Wireless Subsystems (WSS)
Click on the WSS tab in the upper row. As the second row of tabs in Figure6-3
shows, there are six menus for configuring a WSS:
• Frame — Used to specify how the wireless signal will be framed and synchro-
nized.
• Channel — Used to configure the wireless communication channel.
• Radio — Used to configure the radio and antenna connected to the WSS.
• Multiple Subnet — Used to specify at least one subnet and mask per WSS.
• CD Packet —
• Preamble —
The WSS Configuration — Edit WSS File: field on the Frame menu allows you
to load an existing WSS configuration file, causing all of the WSS menus to dis-
play the current settings for that WSS file. You can then either modify that file, or
save it under another name.
You will need to create a separate configuration for each WSS. The basic procedure
is as follows:
1. Start with the WSS — Frame menu (Figure6-3). If desired, use the Edit WSS
File field to load an existing WSS configuration as a template.
2. Complete the other WSS menus as described on the following pages.
3. Click on the Generate WSS Config button, and specify the WSS you are con-
figuring.
4. Repeat for all WSSs.