User's Manual

CHAPTER 6. BSU AND S UBSCRIBER CONFIGURATION
6–34070-20000340-01 Rev A
Table6-P CPE — Classifier Parameters
Parameter Range
(and Default)
Comments
Classifier Reference N/A ID number of the current classifier; increments as
each new instance is opened.
Service Flow Reference Menu of existing SIDs
(0)
Choose the service flow to which packets matching
this classifier will be assigned.
TOS Type (Low, High,
Mask)
If desired, specify the matching parameters for the
IP ToS byte range and mask. An IP packet with IP
ToS byte value “ip-tos” matches this parameter if
tos-low <= (ip-tos AND tos-mask) <= tos-high.
IEEE 802.1P User Priority,
High and Low
1 to 7 for each
(1)
Specify the high and low limits for user priority.
Activation State Inactive or Active
(Active)
Specify whether this classifier is to be active or inac-
tive. (This allows classifiers to be defined, then
turned on or off.)
Activation Signal
IP Protocol * Any, ICMP-1, TCP-6,
UDP-17
(Any)
EnetType/802.2 SAP * (no default) Specify the Ethernet frame type:
For Version 2 or SNAP Ethernet Frame type, enter
a value from 10000 -to 1FFFF
For IEEE 802.2 Ethernet Frame Type, enter a value
from 20000 to 2FFFF
Source IP Address * xxx.xxx.xxx.xxx decimal
(no default)
Specify a source by IP address.
Source Subnet Mask * xxx.xxx.xxx.xxx decimal
(255.255.255.255)
Specify a destination subnetwork by entering an IP
subnet mask.
Source Port Start * 0 to 65535
(no default
Specify a range of destination ports.
Source Port End * 0 to 65535
(no default
Source MAC Address * xx.xx.xx.xx.xx.xx hexa-
decimal (no default)
Specify a source by MAC address.
Destination IP Address * xxx.xxx.xxx.xxx decimal
(no default)
Specify a destination by IP address.
Destination Subnet Mask * xxx.xxx.xxx.xxx decimal
(255.255.255.255)
Specify a destination subnetwork by entering an IP
subnet mask.