User's Manual

6–27070-20000340-01 Rev A
CHAPTER 6. BSU AND S UBSCRIBER CONFIGURATION
Configuring Packet Filters
This feature is not supported in R1P1.
Table6-M CPE — SNMP Parameters
Parameter Range
(and Default)
Comments
Total Configured Hosts 1 to 32 Read-only field indicating how many SNMP hosts
have been specified.
Send Trap Yes or No
(Yes)
Specify whether SNMP traps will be sent to trap-
enabled hosts (per Access Right configurations).
Host ID 1 to 32 (increments as
instances are opened)
Identifies the SNMP host being configured.
Access Right readOnly, readWrite,
roWithTraps,
rwWithTraps, trapsOnly
(readWrite)
Specify the SNMP access this master will have.
Host IP Address xxx.xxx.xxx.xxx decimal
(0.0.0.0)
Specify the IP address of this SNMP manager.
Read Community Up to 79 characters
(public)
Specify the name of the community which will have
read access to the subscriber Indoor Unit.
Write Community Up to 79 characters
(private)
Specify the name of the community which will have
write access to the subscriber Indoor Unit.