User's Manual

6–19070-20000340-01 Rev A
CHAPTER 6. BSU AND S UBSCRIBER CONFIGURATION
Server IP Parameters
Click on the Server IP tab so that the screen illustrated in Figure6-8 is displayed.
Three server IP addresses are configurable, as identified in Table6-H. Specify any
server IP addresses as desired.
Syslog and SMTP server identifications made on this menu will be overridden by
Syslog and SMTP server identifications made in the DHCP server configuration.
NOTE: TFTP and DHCP server addresses are not configurable; they are learned
from the DHCP server when the BSU boots up.
Bridging/Clustering Parameters
Click on the Bridging/Clustering tab so that the screen illustrated in Figure6-9 is
displayed. Specify bridging and clustering options as described in Table6-I.
Clustering allows two or more WSSs to be on the same subnet, which can provide
greater efficiency in the use of IP addresses. Subscriber-to-subscriber (CPE-to-
CPE) bridging makes communications between subscribers in the same subnet
more efficient.
Configuring SNMP Parameters
Click on the SNMP tab in the upper row, so that the screen illustrated in Figure6-10
is displayed.
Specify parameters for Host 1, as indicated in Table6-J. Click on the save instance
icon when you are finished.
If desired, open a new Host by clicking on the open instance icon. Specify parameters
for the new host. Click on the save instance icon when you are finished. Repeat for
as many hosts as desired (to a maximum of 32).