User's Manual
Table Of Contents
- Scope of This Manual
- Conventions Used in This Manual
- Intended Audience for this Manual
- General Cautions and Warnings
- List of References
- Overview Of Subscriber Station
- Installation of Subscriber Station
- Aperto Installation Manager
- Specifications
- Event Reporting
- Cables, Spares and Accessories
- Command Line Interface (CLI)
- Virtual Local Area Network
- Troubleshooting
- LIMITED EQUIPMENT WARRANTY (“Agreement”)
F–5
PacketMax 100 User Manual, 10007306, Rev J
Chapter F. Troubleshooting
Figure F-3 Security dialog box
g. Power off the SS and start it again.
h. Now the SS boots up from your PC and you will hear the beep for ARM1
bootup.
i. Telnet to SS and change the boot parameters as below:
telnet <ss_ip_address> 5000
login:- isp
password:- isp
SS Main> bootChange
'.' = clear field; '-' = go to previous field; ^D = quit
boot device : tffs=0,0
processor number : 0
host name : host
file name : /tffs0/arm0_ss1_0_0.D
inet on ethernet (e) : 192.168.2.100:ffffff00
inet on backplane (b): 127.0.1.1:ffffff00
host inet (h) : 192.168.2.55
gateway inet (g) : 192.168.10.1
user (u) : vxuser
ftp password (pw) (blank = use rsh): vxuser
flags (f) : 0x2008
target name (tn) :
startup script (s) :