User's Manual

D–2
PacketMax 100 User Manual, 10007306, Rev J
Chapter D. Command Line Interface (CLI)
c. To display information about the use of a specific commands, including
command parameters, enter the command followed by ?.
5. When you are finished with the CLI, end the Telnet session by entering the
logout command or simply closing the Telnet application.
4.1.1 Commands
Some Subscriber Unit CLI commands are defined in Table D-1. All commands are
case-sensitive. Please refer to the Command Line Interface Reference Manual Rev
B, for further CLI details.
4.1.2 Error Messages
Error messages which may be returned by the Subscriber Unit CLI include the follow-
ing:
 Error: Bad Command — command has been entered incorrectly.
 Error: Invalid Parameter — command has been entered incorrectly.
 Verification failed: Invalid use/current password — when setting a password, user-
name or password entries do not match.
Table D-1 Subscriber Unit CLI Commands
Command Function
killTelnet Causes the CLI to terminate all current Telnet sessions con-
nected at port 5000.
reboot Reboots the Subscriber Unit.
config dhcp params Configures dhcp params
config vlan params Sets vlan parameters.
config password These commands set passwords for any login CLI prompts for
old and new password.
show dhcp params Shows the DHCP parameters, including IP address, subnet
mask, and gateway, TFTP servers, and config file name.
show device running config file Generates the Subscriber Unit’s configuration file in text format.
File is stored in /ram0 directory.
show frequency params Displays frequency of SS.
show vlan params Does not apply to Subscriber Unit.
show config vlan Shows the management VLAN parameters.
show system Displays system parameters, for e.g.:, location, memory-info and
ss-model, etc.
show wimax status Displays some status parameters, for e.g:, currentTXpower, Ds-
modulation and tffso-free-bytes, etc.