User's Manual
Table Of Contents
- Scope of This Manual
- Conventions Used in This Manual
- Intended Audience for this Manual
- General Cautions and Warnings
- List of References
- Overview Of Subscriber Station
- Installation of Subscriber Station
- Aperto Installation Manager
- Specifications
- Event Reporting
- Cables, Spares and Accessories
- Command Line Interface (CLI)
- Virtual Local Area Network
- Troubleshooting
- LIMITED EQUIPMENT WARRANTY (“Agreement”)
3–8
PacketMax 100/300 User Manual, 10007306, Rev J
Chapter 3. Aperto Installation Manager
Figure 3-6 Configure Other Frequencies Window
6. Use the drop-down menu to select the Channel Width. If you are unsure, stick
with the default selection. 3.0, 3.5, 5.0, 5.5 and 7.0 MHz are supported.
7. For VLAN applications, specify the Management VLAN ID and Management
VLAN priority. Usually, the Management VLAN ID should be the same for the SS
and BS. If you leave the value at the default of 0, the SS will automatically learn and
use the BS’s Management VLAN ID.
NOTE: VLAN configuration is performed primarily using the Configuration
Manager. Only the VLAN management ID and priority can be set locally using
the AIM.
8. When the restart is finished, the AIM will go into antenna alignment mode, dis-
playing the Alignment Window shown in Figure 3-7.
Figure 3-7 Alignment Window