User's Manual
Table Of Contents
- Scope of This Manual
- Conventions Used in This Manual
- Intended Audience for this Manual
- General Cautions and Warnings
- List of References
- Overview Of Subscriber Station
- Installation of Subscriber Station
- Aperto Installation Manager
- Specifications
- Event Reporting
- Cables, Spares and Accessories
- Command Line Interface (CLI)
- Virtual Local Area Network
- Troubleshooting
- LIMITED EQUIPMENT WARRANTY (“Agreement”)
3–5
PacketMax 100/300 User Manual, 10007306, Rev J
Chapter 3. Aperto Installation Manager
3.4.2 AIM Options
The main AIM window lists the following four options:
Import CM Database: Allows the BS xx.DAT file to be copied from the computer
to the PacketMAX device.
Setup: Provides basic configuration, antenna alignment, and throughput test-
ing.
Continue with Setup: Allows to align antenna when basic configuration has
already been completed.
Diagnostic Manager:
3.4.3 Importing the BS XX.DAT File
When BS configuration is performed using the Server Configuration Tool in Element
Management System (EMS) the xx.DAT (where “xx” is the specific BS name) database
file is generated. This file records basic parameters for all configured BSs:
BS name
Sector name
Channel width
Channel frequency
Broadcast polarization
BS diversity
CINR ratio
Frequency band
The Configuration Manager has an option to copy the data file to a diskette.
The Installation Manager allows the data (xx.DAT) file to be downloaded from the com-
puter to the PacketMax 100. The PacketMax 100 will then load all of its configuration
parameters automatically from the xx.DAT file once the SS’s BS and sector are
selected.
To download the xx.DAT file to the PacketMax 100:
1. Click on the Import CM database button on the main screen of the Aperto
Installation Manager.
2. Choose the file and click on Open. A successfully imported dialog box shows
up
3.4.4 Basic Configuration
1. In the Install Option window, select Setup; then click on the Next>> button. The
Configuration Window will be displayed, as shown in
Figure 3-5. The Configu-
ration Window shows the configuration retrieved from the PacketMax 100. The
MAC address should be the same as recorded on the label on the unit.
NOTE: If the data file has been downloaded as described under Downloading
the BS.DAT file section below, the only parameters you need to configure are