User's Manual
Table Of Contents
- Scope of This Manual
- Conventions Used in This Manual
- Intended Audience for this Manual
- General Cautions and Warnings
- List of References
- Overview Of Subscriber Station
- Installation of Subscriber Station
- Aperto Installation Manager
- Specifications
- Event Reporting
- Cables, Spares and Accessories
- Command Line Interface (CLI)
- Virtual Local Area Network
- Troubleshooting
- LIMITED EQUIPMENT WARRANTY (“Agreement”)
2–8
PacketMax 100/300 User Manual, 10007306, Rev J
Chapter 2. Installation of Subscriber Station
Figure 2-7 PM100/300 installed in vertical polarization (Default)
Horizontal Polarization
As the PM 100/300 only has one antenna array, in order to use horizontal polarization,
it must be turned through 90 degrees so that the antenna array can receive RF signals
that have been transmitted in a horizontal polarization (
Figure 2-8). This can be
achieved when attaching the pole mounting kit so that the orientation is that the CAT5
cables are attached at the side of the PM 100/300. While PM 100/300 is in horizontal
polarization, then all the weather protection precautions must be taken.
NOTE: Please use CAT5 cover that is supplied with the PM 100.
Figure 2-8 PM100/300 installed in horizontal polarization
PM 100/300
Vertical Polarization
Loop used to reduce strain
on RJ45 connector
Horizontal
Polarization