User's Manual
Table Of Contents
- Scope of This Manual
- Conventions Used in This Manual
- Intended Audience for this Manual
- General Cautions and Warnings
- List of References
- Overview Of Subscriber Station
- Installation of Subscriber Station
- Aperto Installation Manager
- Specifications
- Event Reporting
- Cables, Spares and Accessories
- Command Line Interface (CLI)
- Virtual Local Area Network
- Troubleshooting
- LIMITED EQUIPMENT WARRANTY (“Agreement”)
2–4
PacketMax 100/300 User Manual, 10007306, Rev J
Chapter 2. Installation of Subscriber Station
5. Mounting method — The antenna/receiver includes an adjustable bracket for
mounting the unit on a pole that is 1.5 inches (3.8 cm) or 2 inches (5.1 cm) in
diameter. For other mounting options (under an eave or on a chimney, for
example), mounting hardware may be adapted as desired. Any alternate
mounting method should allow adequate adjusting of the antenna direction,
both horizontally and vertically.
2.1.4.1 Safety Requirements
Outdoor installation procedures should be performed by qualified professionals
following all safety and other requirements and acting in accordance with stan
-
dard practices and procedures. Performance of non-standard practices and
procedures or failure to meet safety requirements could result in personal injury
and/or damage to equipment.
Lightning protection is recommended for subscriber equipment. Provide a ser-
vice loop for the cable. Instructions are covered in the 1-Port Power over Ethernet
Midspan User Guide.
Lightning damage is not covered by the product warranty.
WARNING: Always power OFF the PM 100/300 IDU before connecting or discon-
necting the PM 100/300 ODU.
2.2 Installation Process
Step 1. Assemble and mount the Outdoor Unit.
The Outdoor Unit (ODU) includes a rear-mounted bracket. This standard mounting
bracket allows the ODU to be mounted on a pole with a diameter of 1.5 or 2 inches
(3.8 or 5.1 cm).