User's Manual
Table Of Contents
- Scope of This Manual
- Conventions Used in This Manual
- Intended Audience for this Manual
- General Cautions and Warnings
- List of References
- Overview Of Subscriber Station
- Installation of Subscriber Station
- Aperto Installation Manager
- Specifications
- Event Reporting
- Cables, Spares and Accessories
- Command Line Interface (CLI)
- Virtual Local Area Network
- Troubleshooting
- LIMITED EQUIPMENT WARRANTY (“Agreement”)
E–4
PacketMax 100/300 User Manual, 10007306, Rev J
Chapter E. Virtual Local Area Network
Figure E-2 Inband Management
It is recommended to connect EMS server and Base station unit in the same VLAN,
for the ease of management and quick troubleshooting incase of any failures.
E.4 VLAN Classifiers
The VLAN switch identifies traffic corresponding to each LAN interface by attaching a
VLAN tag to the Ethernet frame as the traffic is switched to its WAN interface. The
Ethernet switch provides isolation of one customer LAN traffic from another custom
-
ers. As each customer’s traffic can be identified with a VLAN ID, it can be mapped
onto an individual Service Flow enabling individualized QoS on a per customer basis.
A VLAN Classifier is a set of rules that determine how the PM 100/PM 300 assigns a
VLAN ID and priority to a packet based on a wide range of packet parameters such
as:
Source or destination IP address(es).
Source or destination MAC address(es).
IP TOS.
EMS Server
Router
Internet
VLAN Switch
DHCP/TFTP over
Backhaul Port
BS
SS
Trunk carrying Data and
Management traffic Connection