User's Manual
Table Of Contents
- Scope of This Manual
- Conventions Used in This Manual
- Intended Audience for this Manual
- General Cautions and Warnings
- List of References
- Overview Of Subscriber Station
- Installation of Subscriber Station
- Aperto Installation Manager
- Specifications
- Event Reporting
- Cables, Spares and Accessories
- Command Line Interface (CLI)
- Virtual Local Area Network
- Troubleshooting
- LIMITED EQUIPMENT WARRANTY (“Agreement”)
D–1
PacketMax 100 User Manual, 10007306, Rev J
Command Line Interface (CLI)
Each Subscriber Station includes a simple command line interface (CLI) accessible
via telnet. The CLI is intended primarily for troubleshooting and debug use under
direction of Aperto personnel.
NOTE: CLI is not a supported management interface.
D.1 Accessing and Using the CLI
To access and use the Subscriber Unit’s command line interface:
1. Telnet to the Subscriber Unit’s IP address.
2. At the Login: prompt, enter the desired logon level: ISP. (There is also a Debug
logon level, which is reserved for Aperto use.)
NOTE: All CLI entries, including user name and password, are case-sensi-
tive.
3. At the Password: prompt, enter the correct password for the specified logon
level.
NOTE: The default password is isp. Passwords can be changed via the
WaveCenter Configuration Manager, SNMP, and the CLI.
4. When the CLI# prompt appears, you are in the CLI.
a. For a list of commands, type ? (the ? will not appear on the screen; press-
ing [Enter] is not necessary). The CLI will respond with a list of the avail-
able commands groups.
b. To see the specific commands in a group, type the group name followed
by ? (again, the ? will not appear, and pressing [Enter] is not necessary).
D