User's Manual
Table Of Contents
- Scope of This Manual
- Conventions Used in This Manual
- Intended Audience for this Manual
- General Cautions and Warnings
- List of References
- Overview Of Subscriber Station
- Installation of Subscriber Station
- Aperto Installation Manager
- Specifications
- Event Reporting
- Cables, Spares and Accessories
- Command Line Interface (CLI)
- Virtual Local Area Network
- Troubleshooting
- LIMITED EQUIPMENT WARRANTY (“Agreement”)
C–3
PacketMax 100 User Manual, 10007306, Rev J
Chapter C. Cables, Spares and Accessories
3.1.3 PacketMAX Subscriber Station Spares and Surge Protector
C.2 Rubber Boot
As mentioned in the Installation chapter, Aperto recommends industrial CAT 5e cable
which meets the ANSI/TIA/EIA 568B.2 Category 5eStandard. In the event that the
above mentioned cable is not available, you must use the included rubber boot, and
use only Industrial CAT5e cable which meets or exceeds ANSI/IIS/EIA 568B.2 Cate
-
gory 5e standards that do not exceed 7.8 mm 0D. Product warranties will be void if
these specifications are not met.
Figure C-1 displays the parts of the rubber boot in an
assembly, while Table C-4 lists the name and description of the parts,
The procedure for installing the rubber boot is:
1. As shown in Figure C-1, slide the Sealing Nut (8), Seals (7), Clams Ring (6),
Gasket (5), Screw Nut (4) and Body (3) in to the CAT 5e cable.
2. Strip the cable and crimp in to the Plug (ethernet connector, 2) after attaching
the Gasket (1) to the Body (3).
3. Plug the ethernet connector (2) and then turn the Screw Nut (4) to tighten.
Figure C-1 Rubber boot for CAT5 Cable
Table C-3 Cable Specs
Part Number
Product Description
Spare Pole Mounting Kit for PM100 and PM300 CPE PM100/300-POLEMOUNT