User's Manual
Table Of Contents
- Scope of This Manual
- Conventions Used in This Manual
- Intended Audience for this Manual
- General Cautions and Warnings
- List of References
- Overview Of Subscriber Station
- Installation of Subscriber Station
- Aperto Installation Manager
- Specifications
- Event Reporting
- Cables, Spares and Accessories
- Command Line Interface (CLI)
- Virtual Local Area Network
- Troubleshooting
- LIMITED EQUIPMENT WARRANTY (“Agreement”)
3–11
PacketMax 100/300 User Manual, 10007306, Rev J
Chapter 3. Aperto Installation Manager
3.4.6 Re-aligning the Antenna (Continue with Setup Mode)
The Continue with Setup option on the Install Option window provides direct access
to the antenna alignment function (Alignment page) without going through the config
-
uration steps.
To align the antenna using the Continue with Setup mode:
1. Go to the Install Option window (Figure 3-4) and select Continue with Setup and
click Next. The Subscriber Station reboots and the AIM displays the Alignment
Window, as shown in
Figure 3-7.
2. Perform the steps under Aligning the Antenna.