User's Manual
Table Of Contents
- Scope of This Manual
- Conventions Used in This Manual
- Intended Audience for this Manual
- General Cautions and Warnings
- List of References
- Overview Of Subscriber Station
- Installation of Subscriber Station
- Aperto Installation Manager
- Specifications
- Event Reporting
- Cables, Spares and Accessories
- Command Line Interface (CLI)
- Virtual Local Area Network
- Troubleshooting
- LIMITED EQUIPMENT WARRANTY (“Agreement”)
3–3
PacketMax 100/300 User Manual, 10007306, Rev J
Chapter 3. Aperto Installation Manager
1. Ensure that the Interface Box is connected to the Outdoor Unit as described
under Connecting the ODU to the Interface Box section.
2. Connect the computer to the Interface Box LAN port using a crossover Ethernet
cable.
3. Ensure that there is only one active Ethernet interface on the computer. (If there
are multiple active Ethernet interfaces, the AIM cannot determine which to use.)
4. Ensure that the computer has a fixed IP address, and not one set by a DHCP
server.
Figure 3-1 gives an example of setting a fixed IP address on Windows
2000; be sure to select Use the following IP address. It does not matter what
IP address, network mask, and gateway are used.
Figure 3-1 Windows 2000 IP Address Setting
3.4 Working with the Aperto Installation Manager
3.4.1 Logging into Aperto Installation Manager
To log into AIM
1. Double-click on the Aperto Installation Manager icon on the PC’s desktop. This
will cause the Authentication window to be displayed, as shown in
Figure 3-2.