User's Manual
Table Of Contents
- Scope of This Manual
- Conventions Used in This Manual
- Intended Audience for this Manual
- General Cautions and Warnings
- List of References
- Overview Of Subscriber Station
- Installation of Subscriber Station
- Aperto Installation Manager
- Specifications
- Event Reporting
- Cables, Spares and Accessories
- Command Line Interface (CLI)
- Virtual Local Area Network
- Troubleshooting
- LIMITED EQUIPMENT WARRANTY (“Agreement”)
2–6
PacketMax 100/300 User Manual, 10007306, Rev J
Chapter 2. Installation of Subscriber Station
screw. Attach a Hex Nut on the other end to secure the ODU to the Inner pole
support.
Figure 2-5 shows insertion of the M5x35 Screw.
5. Position the clamp around the pole in the desired location. Install and tighten
the clamp bolts enough to secure the clamp to the pole. Tighten these screw
only after antenna pointing.
NOTE: The polarization of the BS antenna should match that of the cpe.
6. Adjust the azimuth and elevation orientation of the radio/antenna as necessary
by loosening the appropriate nuts, repositioning the ODU (refer to section 1.2),
and finally tightening the nuts.
Figure 2-6 shows an installed PacketMax 100.
Figure 2-3 Attaching Base Support to ODU
Figure 2-4 Pole Support Assembly
M5 Lock Washer
M5X35 Screw
M5 Lock
Washer
M5 Flat
washer
M5x20 Screw