User's Manual

2–5
PacketMax 100/300 User Manual, 10007306, Rev J
Chapter 2. Installation of Subscriber Station
Figure 2-1 Mounting Hardware Parts
Figure 2-2 Mounting the PM 100/300-ODU
To mount an Outdoor Unit on a pole using the bracket, follow the instructions below:
1. Locate the appropriate mounting holes for the bracket on the back of the ODU.
2. Attach the mounting bracket (Base Support) to the ODU using four M5X20
screws provided. Place the Flat washers and M5 Lock washers on the Base
Support and then insert M5X20 screw. Tighten the screw.
Figure 2-3 shows the
M5x20 screws securing the Base Support to an ODU.
3. Attach the Inner Pole Support and Outer Pole Support with M8X100mm Long
Screws. Place one Flat washer and one M8 Lock washer each (both ends of
the pole supports) before inserting the screw from the inner pole support to the
outer pole support. Attach a M8 Hex Nut on the other end of each M8 Long
Screw. Do not tighten the M8 Hex Nuts yet.
Figure 2-4 displays a pole support
assembly.
4. Attach the Base Support on to the Inner pole support by inserting a M8x100
mm Screw. Place a Flat washer and a M8 lock washer before inserting the