User's Manual
Table Of Contents
- Scope of This Manual
- Conventions Used in This Manual
- Intended Audience for this Manual
- General Cautions and Warnings
- List of References
- Overview Of Subscriber Station
- Installation of Subscriber Station
- Aperto Installation Manager
- Specifications
- Event Reporting
- Cables, Spares and Accessories
- Command Line Interface (CLI)
- Virtual Local Area Network
- Troubleshooting
- LIMITED EQUIPMENT WARRANTY (“Agreement”)
2–2
PacketMax 100/300 User Manual, 10007306, Rev J
Chapter 2. Installation of Subscriber Station
2.1 Installation Requirements
2.1.1 Hardware and Software Requirements
Aperto Installation Manager (AIM). AIM is a software utility that helps to config-
ure PacketMAX 100/300 devices, optimize antenna alignment, perform ping
tests, and pre-provision PacketMAX 100/300 devices for later deployment.
Laptop/desktop that has Aperto Installation Manager installed.
2.1.2 Cables and Connector Requirements
You will also need the following cables and connectors:
Shielded Cat 5 cable (outdoor rated), long enough to run between Indoor and
Outdoor Units, and two shielded RJ45 male connectors
Ethernet cable with RJ45 male connectors (straight-through for connection to
hub, or crossover for connection to computer)
Please refer to the Cable Specs for further details under section C.1.2, in Appendix C.
Table 2-1 Subscriber Site Cable Requirements
Connection Qty Cable Type Max. Length Connectors
Radio Con-
trol
1 Shielded Cat 5,
Outdoor-rated
50 m (100 ft) RJ45 male
1 Shielded Cat 5E,
Outdoor-rated
100 m (330 ft) RJ45 male