User's Manual
Table Of Contents
- Scope of This Manual
- Conventions Used in This Manual
- Intended Audience for this Manual
- General Cautions and Warnings
- List of References
- Overview Of Subscriber Station
- Installation of Subscriber Station
- Aperto Installation Manager
- Specifications
- Event Reporting
- Cables, Spares and Accessories
- Command Line Interface (CLI)
- Virtual Local Area Network
- Troubleshooting
- LIMITED EQUIPMENT WARRANTY (“Agreement”)
1–2
PacketMax 100/300 User Manual, 10007306, Rev J
Chapter 1. Overview Of Subscriber Station
1.1 PM 100/300 Package Contents
PM 100 or PM 300 Radio (ODU) with either an integrated antenna or Type-N
connector
Power-over-Ethernet Injector (IDU) and User Guide
Pole Mount Bracket Kit 1.0 to 3.0 inches (2.54 to 7.62 cm)
Weatherproof Connector
Cat5 indoor Ethernet Cable (5 ft/150 cm)
AC Power Cord
Quick Installation Guide and Warranty Card
1.2 Subscriber Station
PacketMax 100/300 Series subscriber stations consists of an Outdoor Unit (radio/
antenna), and a Power over Ethernet (PoE).
Figure 1-1 PacketMax Subscriber Equipment
1.2.1 PacketMax 100/300 Outdoor Unit (ODU)
The outdoor unit integrats all communication, networking, RF and antenna functions.
The ODU has a maximum average power output of 20 dBm at 64QAM modulation
and it supports variable channel widths 3.0, 3.5, 5.0, 5.5 and 7.0 MHz. The bandwidth
Management is handled by service flows such as CBR, CIR and BE.
The internal antenna has the following specifications:
15 dBi gain
Vertical Polarization
Data Out to
PM 100/300
ODU
Data In to
PC/hub
Power Over
Ethernet (PoE)
AC Supply