User's Manual
Table Of Contents
- Scope of This Manual
- Conventions Used in This Manual
- Intended Audience for this Manual
- General Cautions and Warnings
- What is new?
- Overview Of Base Station
- 1.1 Conceptual Overview of the PacketMax System
- 1.1.1 Cell Size, Capacity, and Scalability
- 1.1.2 Frequency Bands
- 1.1.3 PacketMax Network Connectivity
- 1.2 Bridge Mode and VLAN Mode of Base Station
- 1.2.1 Bridge Mode
- 1.2.2 VLAN Mode
- 1.2.3 Point-to-Point Mode
- 1.3 Features of PacketMax System
- 1.3.1 The PacketMax System’s IP Network
- 1.3.2 Services
- 1.3.3 MIBs
- 1.3.4 Service Offerings and QoS
- 1.3.5 ARQ Feature
- 1.3.6 3 DES Encryption
- 1.3.7 Certificates and Management
- 1.3.8 Upgrades
- Base Station Components
- 2.1 PacketMAX Base Station
- 2.2 5-Slot ATCA Chassis
- 2.3 Wireless System Controllers
- 2.3.1 Major Differences Between WSC-S-24 and WSC-48
- 2.3.2 One Port WSC-S-24
- 2.3.3 QUAD Wireless Controller (QWC) Card - WSC-48
- 2.3.4 Compatibility matrix with radio
- 2.4 Main System Controller Card
- 2.5 MSC Redundancy
- 2.5.1 Redundancy support
- 2.6 AC Supply
- 2.7 Power LEDs and ESD connector
- 2.8 Hot Swap
- 2.8.1 WSC-48 Hot Swap
- 2.8.2 WSC-S-24 Hot Swap
- 2.8.3 MSC Hot Swap
- 2.9 Maintaining Proper Chassis Air FLow
- 2.10 Fan Unit
- 2.11 Serial Cable Pinout
- 2.11.1 Serial Connection Instructions
- 2.12 PacketMax 5000 Rear Panel
- 2.12.1 Grounding
- 2.12.2 DC Power Connection
- 2.13 AC Power Connection
- 2.13.1 Fuse
- 2.14 Base Station Radio
- Installing the Base Station IDU
- Installing the Base Station ODU Radio and Antenna
- 4.1 Radio Compatibility
- 4.2 Installing the Antenna
- 4.3 Installing the Base Station Radio ODU
- 4.3.1 3.3 and 3.5 GHz BSR Package Contents
- 4.3.2 5.8 GHz BSR Package Contents
- 4.3.3 Preparing and Mounting the 3.3 and 3.5 GHz BSR
- 4.3.4 Preparing and Mounting the 5.8 GHz BSR
- 4.3.5 Using the BSR with the Antenna and IDU
- Commissioning the Base Station
- 5.1 Summary of Configuration of Base Station
- 5.2 Establishing an Ethernet Connection with Cat-5 Cable
- 5.3 Establishing a Serial Connection to the Base Station
- 5.4 Configuring DHCP
- 5.5 Obtaining the MAC Address of the Base Station
- 5.6 Selecting Management or Data Traffic
- 5.7 Provisioning the Base Station with WaveCenter EMS
- 5.8 Rebooting the Base Station
- 5.9 Verifying Operations
- 5.10 Ensuring Encryption
- 5.11 Upgrading Base Station Manually
- 5.11.1 WSC upgrade
- 5.11.2 MSC Upgrade
- Event Reporting
- Command Line Interface (CLI)
- Cables, Spares and Accessories
- System Specifications
- D.1 Physical interfaces of PM 5000 - 12 sector
- D.2 Physical interfaces of PM 5000 - 4 sector
- D.3 QoS and Networking Parameters
- D.4 Dimensions and Weight
- D.5 Environmental
- D.6 Radio Specifications
- 4.6.1 PM-BSR-33 and PM-BSR-35 Radio Specifications
- 4.6.2 PM-BSR-58 Radio Specifications
- 4.6.3 Antenna Specifications
- D.7 Antenna Types, Maximum Gains and Maximum Output Power Point to Multipoint Operation
- D.8 Transmit Output Power Regulations
- Certifications
- Troubleshooting
D–13
PacketMax 5000 Installation and Operation Manual, 10007678 Rev J
Chapter D. System Specifications
4.6.2.10 Transmitter Specifications
Table D-17 Transmitter Specifications
4.6.2.11 Receiver Specifications
Table D-18 Receiver Specifications
4.6.2.12 Receiver Sensitivity (dBm @ BER 10-6): for 3.5 MHz, 5.5 MHz
and 7.0 MHz
Table D-19 Receiver Sensitivity
Output Power [Guaranteed (avg Pout)] - BPSK -20dBm
- QPSK3/4 - 20 dBm
- 16 QAM3/4 - 20 dBm
- 64 QAM3/4 - 20 dBm
Frequency Step Size 500kHz
Transmit Power Accuracy +/-1dB @ Max output power
+/-3dB over full range.
Manual SW TX Attenuation 30dB
Frequency Stability +- 4 ppm
Phase noise @ 10 KHz offset, -82 dBc/Hz
@ 100 KHz offset, -96 dBc/Hz
@ 1 MHz offset -105 dBc/Hz
Receiver Specifications
Rx Input Dynamic Range 60 dB
Max Rx Input Power, Operational -35dBm
Max. Rx Input Power, No Damage 0dBm
Phase noise @ 10 KHz offset, -85 dBc/Hz
@ 100 KHz offset, -100 dBc/Hz
@ 1 MHz offset -105 dBc/Hz
Rx Noise Figure @ Hi signal input (-30 dBm) 36 dB
@ Lo signal input (-70 dBm) 8 dB
Modulation 3.5 MHz 5.0 MHz 5.5 MHz 7.0 MHz
BPSK-1/2 -92 -98 -90.0 -94.0
QPSK-1/2 -89 -96.2 -87.0 -92.4
QPSK-3/4 -86 -94.3 -84.5 -89.1