User's Manual

8–25070-20000340-01 Rev A
CHAPTER 8. MANAGEMENT INTERFACES
SNMP
Each subscriber Indoor Unit includes an SNMP agent. Each Base Station Unit
includes an SNMP agent plus a proxy agent for the subscriber Indoor Units. The
agents support the following MIBs:
SNMP MIB (RFC 1157)
MIB II (RFC 1213)
Aperto private MIB
Additional MIBs, as appropriate, for plug-in backhaul modules.
The complete MIBs are provided on the PacketWave CD-ROM, and are available on
the Aperto Web site, www.apertonet.com.
The SNMP agents support trap reporting. Trap-reporting parameters can be specified
via the Configuration Manager and the Web GUI as well as via SNMP.
NOTE: SNMP parameters are read-only in R1P1.
SYSLOG
The Base Station Unit and subscriber Indoor Unit supports logging of event messages
to a designated server according to the Syslog protocol. The Syslog server may be
identified in the DHCP configuration or the BSU and SU configuration files.
COMMAND LINE INTERFACE (CLI)
Each Base Station Unit and subscriber Indoor Unit includes a simple command line
interface (CLI) accessible via telnet and, for the BSU, directly via the front panel.
To use the CLI:
1. Establish a connection in one of the following ways.
Telnet to the Base Station Unit’s or subscriber Indoor Unit’s IP address.
Enter the correct user name (Aperto) and password (Aperto) as prompted.
Connect a computer directly to the BSU’s RS-232 port, and open a terminal
emulator configured for 38.4K baud, 8 bits, 1 stop bit, no parity. Press
Return until prompted for Login. Enter the correct user name (Aperto)
and password (Aperto).