User's Manual

6–13070-20000340-01 Rev A
CHAPTER 6. BSU AND S UBSCRIBER CONFIGURATION
Table6-D BSU — WSS — Channel Parameters
Parameter Range
(and Default)
Comments
Channel Center Freq (MHz) 9 menu options for
frequency range, plus
center frequency field
Select the frequency range from the drop-down
menu; then enter the channel center frequency to be
used in communication with all subscribers in the
sector.
Required field.
Symbol Rate Ratio range x to y : a to b
(1 : 1)
Advanced configuration parameter; change only if
directed by Aperto Networks. Not supported in
R1P1.
Sector name (no default) Enter the name chosen for the sector served by this
WSS.
Sector Number 1 to 6
(1)
Choose a number to identify the sector. Generally,
you should use the WSS port number.
Channel Width 1000 to 7000 kHz
(6000)
Not supported in R1P1.
Channel ID 0 to 15
(1)
Specify a channel identification number.
Symbol Rate Allowed 1 or 2
(1)
Advanced configuration parameter; change only if
directed by Aperto Networks. Not supported in
R1P1.
Flow ID Bits in SID 1 to 6
(2)
Advanced configuration parameter; change only if
directed by Aperto Networks. Not supported in
R1P1.
CPE ID Bits in SID 2 to 10
(10)
Advanced configuration parameter; change only if
directed by Aperto Networks. Not supported in
R1P1.
Ranging Tx Power Steps 2 to 16 dBm,
(4)
Specify the step size for transmit power ranging.
Antenna Gain 0 to 48 dBi(15) Not supported in R1P1.
CIR Bandwidth Allocation 0 to 100%
(0)
Specify the percentage of the total bandwidth to be
devoted to each of the three service classes.
The three percentages should total exactly 100%.
They should also correlate to the total bandwidths
assigned to all subscribers in the sector, with appro-
priate oversubscription based on statistical multi-
plexing expectations.
CBR Bandwidth Allocation 0 to 100%
(0)
Best Effort Bandwidth
Allocation
1 to 100%
(100)