Installation manual

ManualsBrandsApenGroup ManualsHeaterAermax line

Aeromax Plus Pre Commissioning Report and Checklist

Commissioning

Site Address

Installing Contractor

Size/Model of Heat Pump

Circulating pump size

Commissioning Date

Make/Model of Cylinder

Serial Number

Heat Pump Installation

Outdoor unit location correct (see manual)* Yes No

Base plate knockouts removed (see manual)* Yes No

Provision made for condensate removal* Yes No

Anti-vibration pads fitted* Yes No

Unit correctly secured to base* Yes No

Comfort Module installed* Yes No

Back-up heater installed (Bi-valent parallel system)* Yes No

Boiler installed (Bi-valent alternative system)* Yes No

Plumbing Installation

Flexible hoses installed* Yes No

Flow and return connected correctly (R top and F Bottom)* Yes No

Isolation valves installed externally* Yes No

External Pipework Insulated.* Yes No

Flush and fill ports installed* Yes No

Danfoss W Plan valve installed (Port A to Hot Water)* Yes No

Circulating pump installed on return* Yes No

System filter installed on return* Yes No

Flow setter fitted on return.* Yes No

Auto Air vent fitted at highest point.* Yes No

Is the system fitted a bivalent one* Yes No

Heat emitter type * Underfloor Radiators Fan coils Ufloor + radiators

Electrical Installation

Electrical isolation switch fitted adjacent to heat pump* Yes No

Electrical isolation switch rating* Amp

MCB/Fuse rating Amp

Link wire installed between terminals 3 & 7 on outdoor unit*† Yes No

Danfoss FP715 Hot Water programmer fitted* Yes No

Cylinder Thermostat fitted* Yes No

Danfoss TP5000 room stat fitted* Yes No

Kingspan diagnostic indicator fitted*† Yes No

Kingspan Advanced Controller (NUI) fitted (Optional).*† Yes No

Commissioning

System flushed with cleanser* Yes No

System checked for leaks* Yes No

Antifreeze added to system… concentration level. * Yes No

Air removed from primary circuit* Yes No

Pump operating* Yes No

Diverter valve operating* Yes No

Aeromax Plus operating* Yes No

Selected heat curve (enter 1 – 12 or custom)(default = 9)†

What is the flow rate set to LPM

Record Flow Temperature ° C

Record Return Temperature ° C

Record outdoor air temperature ° C

What is the bivalent point (OAT that boiler is turned on at) ° C

*Delete as required † Not applicable if Comfort Module installed - see Comfort Module commissioning sheet