Installation manual

65
a) Press PROG until the first preset
time and temperature (Event 1 for
Programme A) appears in display.
b) Use the + and - buttons to adjust the TIME (press and
hold to change in 10 minute increments).
c) Use the ‡ & ˆ buttons to adjust the required
TEMPERATURE.
d) Press PROG to move to the next preset time and
temperature (Event 2).
e) Repeat steps b, c, & d to programme the
remaining events
Setting the correct time
a) Press PROG until the first preset
time and temperature (Event 1 for
Programme B) appears in the display.
b) Use the + and - buttons to adjust the TIME (press and
hold to change in 10 minute increments).
c) Use the ‡ & ˆ buttons to adjust the required
TEMPERATURE.
d) Press PROG to move to the next preset time and
temperature (Event 2).
e) Repeat steps b, c, & d to programme the
remaining events.
Programming “B” programme days and events
Press + and - together to change between settings.
Altering the display to show time or temperature
Press PROG to return to previous RUN mode. The
heating will now follow the times and temperatures
programmed.
Running the programme
User Overrides
Press ‡ & ˆ until required temperature is displayed.
Please note that your installer may have restricted both
upper and lower temperature settings and the temperature
override limits. This override will automatically be
cancelled at the beginning of the next programmed event.
Press ‡ and - together to toggle between day numbers
and text.
To change day of week legends from numbers to text
Programmable room stat
Temporarily alter current programmed temperature
Please note that your installer may have restricted the
duration of the override to something other than next
event.
In this case the override arrow will flash to indicate a
timed override is active during the next event