Installation manual

64
Changing preset programmes for AB programming (Installer setting must be in 5/2 day mode)
(Installer setting must be in 5/2 day mode)
Press and hold PROG and V for 3 seconds. The display will
change to the figure opposite. This will take you into User
Advanced Programming option 1.
Use ‡ & ˆ keys to enable or disable the function
(1=enabled, 0=disabled).
Press PROG for 5 seconds until the display returns
to previous RUN mode.
Press PROG once, the display will change to show
the default days assigned to programme “A” (days
MON, TUE, WED, THU, FRI).
Use the + and - keys to scroll forwards or backwards
through the days of the week.
To deselect a day press V, (for example TUE). To
select a day press (for example SUN).
Any deselected days are automatically assigned to
programme “B”.
For Weekends
Press PROG until the first preset time and
temperature (Event 1 Days SAT, SUN) appears in
display.
Repeat steps b, c, & d above to programme the
remaining weekend events.
Changing the preset programmes in 5/2 day mode
a) Press PROG until the first preset time and temperature
(Event 1 for all days of the week) appears in display.
b) Use the + and - buttons to adjust the TIME (press and
hold to change in 10 min increments).
c) Use the ‡ & ˆ buttons to adjust the required
TEMPERATURE.
d) Press PROG to move to the next preset time and
temperature (Event 2).
e) Repeat steps b, c, & d to programme the remaining
events.
Changing the preset programmes in 24 hour mode
T IM E (press and hold
c) Use the and V buttons to adjust the required T EM PERAT U
Programmable room stat