Manualshelf

Installation manual

ManualsBrandsApenGroup ManualsHeaterAermax line
61626364656667686970
63
After setting the date press PROG to display the time.
The time display will flash on and off.
Use the + and - buttons to set the correct time (press
and hold to change in 10 min. increments).
Setting the correct time
Please Note
The unit must be programmed in sequence, event times cannot be set out of sequence.
If you want to leave a preset time as it is, simply press PROG to move to the next setting.
If you want to return the unit to RUN, press PROG and hold until the display returns to the previous RUN mode.
Alternatively leave alone and the unit will automatically return to RUN after 2 minutes.
Your installer will have set your unit to programme 6, 4 or 2 events per day. This will determine the number of
events per day that you are able to programme.
The day of the week is set automatically. Press
PROG to return to normal operation (RUN).
Setting the correct day
If you are happy with the preset times shown in the table
on page 62 you need take no further action.
Accepting the preset programmes
Before you change the preset programmes Your installer
will have set the unit to operate in one of the following
modes:
• 5/2 day - one set of programmes for weekdays and
another for weekends as per section below
• 24 hr - one set of programmes for the whole of the week
(page 64).
Alternatively
• A/B - The unit can also be set by you to provide two
programme blocks, either of which can be applied to
different days of the week.
If this is required refer to page 64 for instructions on
how to turn on this feature.
Changing the preset programmes
For Weekdays
a) Press PROG until the first preset time and temperature
(Event 1 Days MON, TUE, WED, THU, FRI) appears in
display.
b) Use the + and - buttons to adjust the TIME (press and
hold to change in 10 minute increments).
c) Use the ‡ & ˆ buttons to adjust the required
TEMPERATURE.
d) Press PROG to move to the next preset time
and temperature (Event 2).
e) Repeat steps b, c, & d to programme the
remaining weekday events.
Changing the preset programmes in 5/2 day mode
Programmable room stat