Installation manual

62
Before you start
Open the flap on the front of the programmer and
press the RESET button with a non-metallic object
until the display goes blank. This will ensure that the
micro-computer in the product is operating correctly.
Note: these are also times for
Block “B” programmes
Note: If set up for 4 events per day, events 3 & 4 are skipped. If set up for
2 events per day, events 2, 3, 4 & 5 are skipped. In both cases the events are re-numbered.
Customising the display
For the sake of clarity, the instructions assume that the
display setting uses a 24 hour clock, °C and that days of
the week are shown as text.
All of these settings can be personalised after the
thermostat has been programmed, see pages 65-66
Setting the correct date and time
Your TP5000 Si incorporates a real time clock with
calendar function that automatically changes time in
both Spring and Autumn. The time and date is set in
the factory for the UK time zone, and does not normally
require adjustment.
If you live in another time zone refer to “Time zone off
set” on page 67. However, should it be found necessary
to adjust time or date for any other reason refer to the
following instructions.
Setting the date
Press and hold ‡ and PROG for 3 seconds, to display
date in dd/mm/yy format.
The YEAR number will flash, use ‡ or ˆ to correct the
year.
Use - or + to move to MONTH, then use ‡ or ˆ to
correct month.
Use - or + to move to DATE in month, then use ‡ or ˆ
to correct day in month.
If you attempt to select an invalid date the unit software
will reject it and apply the nearest valid date. It is
recommended that date is set in the order, yy/mm/dd.
Programmable room stat
Weekdays (Mon-Fri)
Event Time Temp. °C
1 06:30 20
2 08:30 15
3 11:30 20
4 13:30 15
5 16:30 21
6 22:30 18
Weekend (Sat-Sun)
Event Time Temp. °C
1 07:30 20
2 09:30 20
3 11:30 20
4 13:30 20
5 16:30 21
6 22:30 18
Note: these are also times for
Block “A” programmes
RESET
PROG for 3 seconds, to