Installation manual

50
1. Press PROG once until SET ON TIME appears at the
top of the display. Note the current day is displayed.
Press the DAY/ HOL button until the required day is
displayed.
Use the + or - buttons to set the time you want your
system to first come on in the morning (Event 1).
2. Press NEXT ON/OFF to move to Event 2.
Continue programming the system ON and OFF times
in this way by using the + or - buttons to set the time
you want and pressing the NEXT ON/OFF button to
move to the next setting.
3. Press DAY/HOL button once only. The next day will
appear at the bottom of the display.
Continue programming the rest of the week by pressing:
a) NEXT ON/OFF button to move to the next setting,
b) + or - buttons to amend the time,
c) DAY/HOL to advance to the next day.
d) To copy the previous day press the COPY button.
4. Press the PROG button to return the unit to RUN
mode (time appears & colon in the display begins to
flash).
5. Proceed to bottom of page 51.
Programming the ON/OFF Times in 7 day mode
7 day hot water programmer