Installation manual

5
Unit protection devices
Check List
The following items are required for the installation of the Aeromax Plus Air Source Heat Pump
Product Code Description
KHP0029 4kW, 6kW & 8kW Installation Pack
KHP0030 12kW Installation Pack
KHP0026 15kW Installation Pack
Pack Contents
2 x 750mm flexible
hoses including 90°
elbow, pre-insulated.
W Plan diverter valve
(heat pump specific)
Anti vibration padsFlush & fill ports
(except 15kW)
Diagnostic indicator 2 x Full bore isolating
valve with lever arm
System Antifreeze / Inhibitor - Clear
Product Code Description
KHP0023 1 x 25 litre system antifreeze inhibitor - Clear
Introduction
The following check list has been prepared to assist you in
understanding the differences from other types of heating
systems you may have installed and help to understand
and comply with all of the technical details contained
within this document to ensure a successful installation.
System cleaning and Water Characteristics
• In the case of a new installation, or cleaning the circuit,
it is necessary to perform a preventive cleaning of the
system. In order to guarantee the good operation of the
product, each time you clean the system, replace the
water or add glycol, check that the liquid appears clear,
without visible impurities and that the hardness is less
than 20°f
• To help protect the heat pump from any heating system
contamination; the system filter should be fitted
internally on the return pipe.
Recommended system cleansers and inhibitors are listed
below.
Fernox F3 System Cleanser
Fernox HP-15c combined antifreeze and inhibitor
Sentinel
All external connecting pipe work should be suitably
insulated using Armaflex or similar.
Radiator System Circuit
• As the Aeromax Plus generates lower temperatures
than a conventional boiler the radiators should have
been designed to suit the lower mean temperature.
• The basic controls within the standard installers pack
and the parameters on the heat pump are optimised
for use on radiator systems.
Retrofit Situations
• The heat exchanger should be protected from
particulate contaminates in the water circuit. The
existing radiator circuit must be chemically cleaned
and thoroughly flushed before installation when fitting
in a retrofit situation.
Installation Pack
1 x 25 litre clear - system
antifreeze inhibitor
25L Heat Pump
Anti Freeze
Concentrate
For systems using under floor heating, boiler
back up or clients wishing to alter the
operating parameters of the unit; we
recommend the purchase of our advanced
controller. See manual for product code
KHP0008.
It is the installer’s responsibility to ensure
correct sizing and provision of both the
domestic circulating pump & any associated
central heating expansion vessel
NOTE
NOTE
1 x System filter
Programmable room stat 7 day hot water
programmer
Flow setter
Immersion Heater
Controller