Installation manual
49
1. Press PROG once until SET ON TIME appears at the
top of the display and MOTUWETHFR appears at the
bottom of the display.
Use the + or - buttons to set the time you would like your
system to first come on in the morning (Event 1).
2. Press NEXT ON/OFF once only.
Use the + or - buttons to set the time you want your
system to go off (Event 2). To move to the next setting,
i.e. when you would like your system to come on again
(Event 3) press the NEXT ON/ OFF button again.
3. Continue programming system ON and OFF times for
weekday Events 4, 5 & 6 as in Step 2.
4. Press the DAY/HOL button once and SASU will appear
at the bottom of the display.
5.To set the times required for SA and SU repeat steps 1
to 3 or if the same settings are required press COPY.
6. Press the PROG button once to return the unit to RUN
mode (time appears & colon in the display begins to
flash).
7. Proceed to bottom of page 51.
Programming the ON/OFF Times in 5/2 day mode
7 day hot water programmer
7 day hot water programmer