Installation manual

48
If you are happy to use the preset programmes on page
47, you don’t need to do anything else.
To accept the factory presets just press the PROG button
once until the time appears and colon in the display
begins to flash.
Your unit is now in RUN mode and will control your
heating
Accepting the preset programmes
Your installer will have set your unit to operate in one of
the following modes:
• 5/2 day - one set of programmes for weekdays and
another for weekends (page 49)
• 7 day - different settings for each day of the week
(page 50)
• 24 hour - one set of programmes for the whole week
(page 51)
See INSTALLER SETTING tick box on inside
flap label to ascertain which mode your unit
is set.
Before you change the preset programmes
These settings are made during manufacture and only
need to be made in the unlikely event that the unit has
lost the settings.
Setting the Date
Press and hold PROG for 5 seconds to display year.
Use the + or - buttons to set the correct year.
Press DAY/HOL to display day and month. Use the + or -
buttons to set the correct month (Jan = 1, Feb = 2 etc.).
Press DAY/HOL to display day and month. Use the + or -
buttons to set day of month.
Press PROG to display the time.
The words SET TIME will appear at the top of the display
& the time will flash on and off .
Use the + or - buttons to set the correct time (press and
hold to change in 10 min. increments).
Setting the Day
The day of the week is set automatically.
Setting the correct Time and Day
DAY/HOL
Please Note
The unit must be programmed in sequence and ON/OFF times cannot be set out of sequence.
If you want to leave a preset time as it is, simply press NEXT to move on to the next setting.
Your installer will have set your unit to programme either 2 or 3 ON/OFFs per day. If your clock has been
installed to allow 3 ON/OFFs and you do not wish to use one of the ON/OFF settings, simply programme the
ON time to be the same as the OFF time and the setting will not operate.
7 day hot water programmer