Installation manual

45
To enter advanced programming press PROG, + and DAY/HOL together and hold for 5 seconds.
Option 1 - (3 or 2 On/Off’s per day)
Use + or - to change between 3 and 2 on/off ’s each day.
Advanced Programming Options
Option 2 - (Disable or enable auto time change)
Press NEXT, then use + or - change between auto time
change
Option 2 - (Disable or enable auto time change)
Press NEXT, then use + or - change between auto time change enabled and auto time change disabled
Option 8 - (Advanced Copy Functions)
Press NEXT, then + or - to change between the
following copy options:
(0) Standard copy in 7 day and 5+2 day.
(1) Enhanced copy in 7 day, standard copy in 5+2 day
(2) Enhanced copy in 7 day, AB copy in 5+2 day.
For an explanation of the copy features and how to use
them please see copy functions explained section
below.
Press PROG to return to RUN.
There are 3 possible copy functions available. These are;
Standard Copy, Enhanced Copy, and AB copy. Copy
functions are enabled/disabled in the Advanced
Programming Options (above).
Standard Copy: Pressing copy will copy the previous days
events into the displayed day. The unit will then display
the 1st event for the new day. This copy function is
present only if the unit is set to run in 5+2 or 7 day
mode.
Enhanced Copy: The enhanced copy function is available
in 7 day mode only. This allows any day to be copied to
any other day, or days. To use the enhanced copy
function go into the event programming using the PROG
button, then:
1. Use the DAY button to find the day to be copied from.
2. Press the COPY button to select the day to be copied
from.
When selected, the day should begin to flash.
3. Use the DAY button to find the day to be copied to.
4. Press COPY button to copy the selected day.
5. Repeat steps 3 and 4 to select and copy other days.
6. To stop copying, use the DAY button to go back to the
flashing day and press the COPY button. The previously
flashing day will stop flashing to indicate it has been
Copy Functions Explained
Please Note:
When a day has been copied to, it will remain visible and not flashing when the DAY button is used to select other
days.
7 day hot water programmer