Installation manual

37
Installation Pack
• Protects against frost damage from -14°C to -34°C
• Protects against corrosion, limescale and bacterial contamination
• Non-toxic
• Compatible with all metals and materials commonly found in heat
Flush & Fill
Anti vibration pads
System Antifreeze / Inhibitor - Clear
Application
Fluid Plus is a concentrated heat transfer fluid capable of frost protection from -14°C to -34°C especially formulated
for use in Heat Pumps. Fluid Plus also provides long term protection from damage caused by corrosion, limescale and
bacteria and maintains a stable pH across a range of operational temperatures. Fluid Plus is compatible with all
materials commonly used in Heat Pumps.
Instructions for use
Dilute before use using mains water. In order to ensure adequate corrosion and biocidal protection, the minimum ‘in-
use’ concentration of the product is 33%. Maximum ‘in-use’ concentration is 50%. Upon dilution Fluid Plus will
provide frost protection according to the table below.
Flow Setter
Install on flow pipework to assist in easy filling of system
Installed under feet of the unit. Designed to withstand extremely high loads & reduce noise.
Dimensions L 76mm x W 76mm x D 22.2
Weight = 100g
To be installed on end of flexi hose so that the unit can be isolated without the need to drain the
system completely
Installed on the return pipe work after the pump allowing 200mm gap between them to
avoid turbulence (which may give false readings)
25L Heat Pump
Anti Freeze
Concentrate
Existing heating systems should be cleaned of sludge and limescale deposits before using a suitable Heat Pump cleaner
before adding Fluid Plus.
Health and safety
Fluid Plus is non hazardous but as with all chemicals, care should be taken. If swallowed seek medical advice and
show container or labels. Do not mix with other chemicals. Keep out of reach of children. Safety data sheets available
on request.
2 x Full bore isolating valve with lever
Concentration
33% 40% 50%
Frost Protection -14°C -22°C -34°C